ricoh printer error SC400 img

Ricoh has made a mark on the industry by offering solutions that cater to all users. However, printers are often affected by failures and errors which a non-technical consumer can not understand. Here is a helpful, quick guide on how to fix Ricoh printer error sc400. Error sc400 is one of the most common errors in these printers, and resolving the problem with full precision is important.

The Ricoh Printer Error sc400 usually is due to a dirty image density (ID) sensor on a Ricoh printer. This sensor can be washed by the user instead of paying for a technician to come out. A dirty ID sensor can also cause other problems or errors like Ricoh Printer Error sc400. Wipe them dry with a cloth free. Also, ensure that the five sensors are cleaned.

Here are a few solutions to resolve the error:

Step 1:

  • Turn off the printer.
  • Now, please open the printhead.
  • After that, turn the printer back on.
  • Now you’ll notice that the cartridges are moving left. So even before the cartridges hit the left side, shut down the cover of the printer, but leave the printer turned on.

Step 2:

  • Reset the print head
  • Turn off the printer and leave it turned off for a couple of minutes.
  • Turn the printer back on and check whether or not the problem has been resolved.

Step 3:

  • Remove and clean the print head.
  • Clean the print head plugs with cue tips and/or alcohol.
  • Before turning on your printer, make sure the connectors are completely dry.
  • Press the power button quickly to start the reboot mode on the printer.

Step 4:

  • Gently remove all of the ink cartridges.
  • Now, lift the gray bar where the ink is going.
  • Lift the print head in the middle of the printer while the printer is off.
  • Now, clean the printer with plastic head primers or cleaners.

Step 5:

  • Replace the problematic cartridge
  • Manually check the printer while replacing the cartridge.

Step 6:

Turn off the power of your printer.

Take the paper out and check for any obstructions.

Step 7:

  • Press the power button and copy the printer
  • Wait a couple of minutes.
  • Now, the printer is supposed to start, and you need to start a nozzle check.

Step 8:

  • Close your scanning unit.

The problem can also indicate that the tin tanks are not correctly placed. Try to reseat the ink cartridges and pay attention to the snap sound, which demonstrates that the cartridges are in place. Besides, ensure that the unit is directly connected to the wall outlet. If the device is not directly attached to the wall outlet, it will not be able to work correctly.

If the problem continues, you can contact your nearest technician or call that manufacturer’s toll-free number!

LEAVE A REPLY

Please enter your comment!
Please enter your name here